S30/JDMtailwiring php
Imported page. This page was converted from an archived copy of "S30 JDM Tail Lamp Wiring" (Xenonzcar, fetched 2026-05-15). The conversion was mechanical, so tables, links and formatting may contain conversion artefacts. Compare against the archived copy if something looks wrong. The content belongs to its original authors.
S30 JDM Tail Lamp Wiring
Here we will document the wiring changes needed to use JDM/Euro (amber bottom) tail lights in a US 240Z.
First lets define the US rear lighting, which is different than what Nissan used for the rest of the world.
*WARNING* - Do this diagnosis/mods at your own risk. We Are not responsable for any issues of your own doing.
Lighting Differences
USDM Rear Lighting
| # | Description |
|---|---|
| 1 | Brake and Turn Signal |
| 2 | Brake and Turn (Series 1) Tail Only from 1/71–end |
| 3 | Brake and Turn Signal |
And for comparison, most of the rest of the world got lights configured like this:
JDM and Euro Tails
| # | Description |
|---|---|
| 1 | Brake and Tail Lights |
| 2 | Brake and Tail Lights |
| 3 | Turn Signal and Hazards |
JDM Lens Wiring
The issue has always been that if you install the JDM lenses (amber bottom) with US wiring, you end up with both red and amber lights acting as both brake lights and flashers. Not optimal, to say the least. So what’s the fix? Get a bit creative with wiring.
⚠️ Disclaimer
Unlike most other mods I’ve done to my car—especially in the wiring—this one requires cutting and splicing one or two wires (the exact number depends on your build date) in each tail light wiring harness.
This does not involve cutting the main harness—only the small harnesses with the bulbs in them. I performed this on a spare pair of harnesses, but if you don’t have extras, you’ll need to modify the originals. You have been warned.
USDM Wiring
Here is a diagram of the stock US 240Z brake/rear turn wiring. This diagram is intentionally simplified to show only the most relevant details for this modification.
JDM & Euro Wiring
JDM Conversion Instructions
- Snip the combined brake/flasher wires for the upper bulbs:
- Right side:
Green/Black - Left side:
Green/Red
- Right side:
- Do not cut the wire going to the lower, single-filament bulb. Leave it connected to the wiring connector.
- Insulate the cut ends from the connector.
- Attach a terminal to the snipped ends for later use.
- Run a new wire from the brake light switch (steering column area) to the rear of the car:
- Disconnect the brake light output wire before it goes to the turn signal switch.
- Connect your new wire to the output side of the brake light switch.
- At the rear, connect this new wire to the snipped wires on both sides.
Hybrid (Semi-Divorced) System
The Hybrid system combines the benefits of integrated and divorced brake/turn setups. One bulb per side acts as a dedicated brake light, while the other is integrated with the turn signal. This ensures maximum brake light visibility while turning.
The wiring is essentially the same as the JDM conversion, but with one addition: at the front of the new brake light wire, tap a pigtail into it and connect it to the wire from the turn signal switch that previously connected to the brake switch.
Sources Used
- Write-up and Diagrams by Arne Berglund - IZCC #2958, Member CZCC #8596 Member